3D Printing

I designed this case to keep my MeshCore/Meshtastic base station in the attic. It holds a Heltec v4 alongside a Type-N bulkhead antenna, with cutouts for the OLED, USB, and coax, working buttons, vents that allow airflow while keeping dust out, a post behind the USB connector for a zip tie so the cable can’t work itself loose, and two mounting holes.

A slim, magnet-closed case for carrying Eargasm earplugs. This is a remix of RMTCTRL’s original design with a slot added along the long edges, which makes the halves much easier to pull apart when you’re using strong magnets. Requires four 6mm x 2mm magnets.

A bracket that clips onto the charger for a Philips Norelco Multigroom Series 3000 so the charger holds the trimmer too, instead of leaving it to sit on the counter while it charges. Designed around the MG3740 trimmer and its included A00390 charger.

The fit is intentionally snug to keep it from drooping over time, so I’ve included two versions with different tolerances plus a removal tool in case your print comes out too tight. It prints in the default orientation, but printing at a 45° angle with a few supports gives better strength on both sides.

A replacement cap for the sports water bottle I use for ice hockey. It’s designed for the A&R Clear Straw Water Bottle, or any bottle with a 3/8" (9.5mm) straw.

The inside is slightly rounded to avoid bridging issues, so it should print without supports. I used Ninjaflex, but other TPU filaments will probably work just as well.

New devices means a new 3D-printed remote control holder! Designed in Tinkercad and printed on a FlashForge Creator Pro in black PLA.

I recently bought a Harmony Hub and wanted to store the remote vertically, so I created and printed this simple 3D model to hold it.

I designed and 3D-printed a simple, custom-sized remote control holder to keep my coffee table organized. It holds my:

• Aeotec Z-Wave Minimote
• Roku 3 Remote
• Xfinity Remote
• Vizio TV Remote
• Wiimote Controller

You can see and download the 3D model here: https://www.thingiverse.com/thing:2454008

A 7-segment display shows how many times my league/commonmark library has been downloaded by pulling data from packagist.org.